The speedometer sending unit required for electric speedometers is NOT included in the complete package and must be purchased separately.

Complete Package Comes With:

• Oil Pressure and Water Temperature Sending Units
•  Speedometer / Tachometer Combination Gauge
•  Fuel Level, Oil Pressure, Water Temperature, and Volt Combination Gauge

Wiring harness is NOT INCLUDED with gauge kits.

Auto Meter Universal 240-33 Ohm Fuel Sender is NOT INCLUDED with gauge kits.

Documents

• Classic Dash General Installation
• Classic Dash Wiring Diagram
• Concourse Series Gauge Instructions
• Electric Speedometer Calibration
• GPS Module Instructions
• 1968-70 MOPAR B-Body Installation
• 1982-84 Firebird Installation
• 1987-93 Mustang Wiring Harness
• 1994-04 Mustang Installation
• 2010-15 Camaro Installation

Tools

What’s Needed For A Dash Installation:

Before embarking on the installation, we recommend rounding up the following tools and supplies:

• Side cutter or “dykes” pliers
• Soldering iron with solder (or “red” butt connectors)
• Electrical/crimping pliers
• Multi-meter (voltage tester)
• Drill motor
• 5/32″ drill bit
• Crazy glue
• Center punch or ice pick
• Tape measure
• Screwdrivers (Phillips & blade type)
• Razor blade or box cutter
• Hand files (fine and medium)
• Open end wrench or socket set (3/8″ through 9/16″)
• Shrink wrap with heating device or electrical tape for connections

PROP 65 WARNING

This product may contain a chemical known by the State of California to cause cancer and birth defects or other reproductive harm. For more information goto https://www.p65warnings.ca.gov/