The speedometer sending unit required for electric speedometers is NOT included in the complete package and must be purchased separately.

INSTALLATION OF THIS PANEL WILL REQUIRE THAT YOU RELOCATE YOUR WIPER SWITCH.

Complete Package Comes With:

• Gauge Wiring Harness*
• Oil Pressure and Water Temperature sending units*
• Turn Signal, High Beam and Parking Brake Indicator (LED Kit)*
• 5″ Speedometer
• 5″ Tachometer
• 2-1/16″ Fuel Level Gauge
• 2-1/16″ Oil Pressure Gauge
• 2-1/16″ Water Temperature Gauge
• 2-1/16″ Volt Gauge

Concourse Series gauge bundles include sending units. Wiring harness and LED kit NOT INCLUDED.

*Wiring harness and sending units are NOT INCLUDED with Sport Comp Mechanical, Ultra-Lite Mechanical and Phantom Mechanical gauge bundles. 

Tools

What’s Needed For A Dash Installation:

Before embarking on the installation, we recommend rounding up the following tools and supplies:

• Side cutter or “dykes” pliers
• Soldering iron with solder (or “red” butt connectors)
• Electrical/crimping pliers
• Multi-meter (voltage tester)
• Drill motor
• 5/32″ drill bit
• Crazy glue
• Center punch or ice pick
• Tape measure
• Screwdrivers (Phillips & blade type)
• Razor blade or box cutter
• Hand files (fine and medium)
• Open end wrench or socket set (3/8″ through 9/16″)
• Shrink wrap with heating device or electrical tape for connections

PROP 65 WARNING

This product may contain a chemical known by the State of California to cause cancer and birth defects or other reproductive harm. For more information goto https://www.p65warnings.ca.gov/